A proven world leader in sealing technology!

Cap Size 70mm Diameter maximum (approx)

Conveyor Speed up to approx 40 metres / minute

Induction Power Rating - Typically 3kW (subject to Conditions)

Wash Down IP65 Electrical Rating / Stainless steel Cladding

Power Requirements 220-250v AC Single Phase

Control System - EN60204 conforming to EMC (Europe or UL508a (US))

E-Stop will integrate into your production line System

The Linear Top Belt Sealer is positioned over any straight length of existing conveyor, immediately after capping takes place. The capped container is guided through the induction tunnel at conveyor speed, where the Linear Belt Sealer applies top pressure to the closure through a non-inductive, compressible re-circulating belt. This unique design helps to ensure that the foil is in complete contact with neck rim by pushing the cap fully down onto the container neck rim in the case of a plastic over-cap or providing full foil contact to the container neck rim in the case of foil only, even where deviations exist in rim levels.

Through full circumferential compression and surface profile conformity, a hermetic seal is achieved. In addition, the sealing process is aided by continued pressure on the cap, following initial release from the induction field.

Contact Enercon today and lower your production costs!

Enquiries and quotes info@enerconind.co.uk